In the bootloader firmware Combiloader the following changes occurred

1. Added new module "SID208 PSA J2534". The module is designed for reading and writing calibration and program the ECU SID208 vehicle Peugeot Boxer/Citroen Jumper diesel engines 2.2 l via the diagnostic connector. The entry of the modified firmware is possible after unlocking the BSL mode (to unlock you need the module "BSL TC17xx J2534"). Supported the calculation of the COP of field calibrations. 


2. Added new module "EMS 3155 Renault". The module is designed for reading and writing calibration and program the ECU EMS3155 vehicle Renault/Nissan with petrol engines 1.2 l via the diagnostic connector. Supported the calculation of the COP of field calibrations. 


3. Added new module "Delphi MT86". The module allows you to read calibrations and a record of the program/calibration diagnostic method, without removing the ECU from the vehicle. Supported the calculation of the COP of field calibrations. Read full flash from ECU you can use the module "BSL TC17xx J2534". The module is available within a kit (General license): Siemens SIM2K C201/241/242/245 Siemens SIM2K 140/141/341/D160, Delphi MT38 and Delphi MT86. 


4. Updated the basic program, the firmware key and documentation. Significant changes and improvements in many modules. Don't forget to update!


In the loader firmware PCMflash following changes occurred: 

1. Added new module 59 "the Renault/Nissan UDS" designed to work with the ECU EMS3155, SID309 working on the UDS Protocol and installed in cars with petrol engines of 1.2 l and diesel 1.5 l Supported read, write, review, and correction checksums. 


2. Added new module 60 "Citroen/Peugeout (PSA) SID208" designed to work with the ECU SID208 fitted to cars with diesel engine 2.2 l Supported read, write, unlock the ECU to record the modified firmware, and test and correction checksums. There is a discount for owners of the Module 53. 


3. In module 18 "Nissan/Infiniti CAN-bus" added support Hitachi ECU mounted on Renault cars Koleos/Latitude with petrol engines 2.5 l Supported read, write, review, and correction checksums. 


4. In module 21 "Ford USA" added support for ECU PCM122 installed on a Ford F350 with gasoline engines 6.0 L. is Supported read, write, review, and correction checksums. 


5. In module 48 "VAG MED17 UDS" added support for ECU MED17.1.21, installed on the cars of concern VAG petrol engines 1.4 L TSI, 3.6 L FSI. Supported virtual read (stock firmware added to the database that is available to buyers module), entry, validation and correction checksums.

2017-12-28 19:16:49
0
76

Comments:

Attention: HTML characters are not allowed!
I have read Security policy and agree with conditions